Archive for August, 2009

How to replace the gasket in faucet?

August 5th, 2009 by admin

Replacing seals in the battery kitchen or bathroom is very simple, but very often call for a plumber. Here you tips that will enable the exchange to you without the help of specialist seals.

Step 1
faucet
Close both the central hot water valve, and cold. Leave the tap until the  with all the water pipes. On the event that the tubes sought relatively large amount of water, prepare a large bowl, cloth and old newspapers.
Step 2
construction of the battery / battery construction tap / tap

Tip of a thin screwdriver weighed the bracket, which cover the screw locking knob, use the key (put it

cloth so as not to damage the battery). The standard battery plug blue means cold water, and red – hot. The batteries of the mixers, we have only one bracket. Do not lever the fixes – if you get to them any contamination of pipes, you must replace the entire battery.
Professional Chicago Maids adn Chicago Commercial Cleaning.

Step 3

Remove the screw that you see the middle tap, turning the key in the opposite direction to traffic
clockwise. Download knob.
Step 4

You may find that you do not need to replace gaskets. Kran can run as gland may be wrong. Try to tighten it. If the water continues to drip replace gasket.
Step 5

Remove the seal at the base dławicy, the imposition of new and all down the back into place. A new gasket must be of the same size as the old. We’ll always keep two or three seals of different diameters, preferably nylon, they are more resistant, to
hot water.
Step 6

Take advantage of this opportunity is to unscrew the tap and clean the strainer, which stop at the sand and other impurities
By blocking the free flow of water. If you want to remove the stone, put it in heated vinegar and leave for ten minutes.
Step 7

After finishing work unscrew the tap water and let drain until the flow is equal to – in this way and avoid the formation of air bubbles inside of the default installation.

Professional Chicago Maids adn Chicago Commercial Cleaning.

How fix pipe?

August 5th, 2009 by admin

The best way would be to avoid fix pipes, especially in the kitchen, however, very difficult to achieve. If you have a problem with clogged pipe below you will find tips on how to fix clogged sink himself without having to call plumber.fix-leak-TP-th-lg

Step 1

Pipes with chemicals

Prepare a solution of 1 / 3 glass of soda and a glass of fine vinegar. Mix everything. Wait until you and all chemical reaction wlej to sink / wash basin. After 5 minutes  hot water. You can also try to clear the pipes with boiling vinegar. If these methods fail, try Crete, etc.
Step 2

Fixer for pipes

Before to the sink, wash basins and a bidet, block wet sponge or cloth overflow hole. In the case of block in the second chamber is not only overflow hole, but also the outflow. Professional Chicago Maids adn Chicago Commercial Cleaning.
Step 3

Enough water to run-off, you want to purge, it was all covered.
Step 4
repairing a clogged sink clogged sink

Touchdown outflow and to press several times that in the tubes was increased pressure, then release and let the water run-off spłynąć. Repeat the operation several times, until the time when you’ll see that flows quite freely.
Step 5
repairing a clogged sink clogged sink 2

Try as far as possible, regularly clean the siphon wash basins. Fundamentals of the bottom of large bowl or bucket, unscrew and remove connectors siphon.
Step 6
3 repair of a clogged sink clogged sink

Clear it and siphon
Wash under running water (sink in another), and if you do not have such an opportunity – in the misc full of water.
Step 7
repairing a clogged sink clogged sink 4

Remove the pipe connecting the tank.
Step 8
5 repair a clogged sink clogged sink

Then, using special spiral wire or pipe cleaners to remove sediment and impurities
.
Step 9
repairing a clogged sink clogged sink 6

Coil cleaning
pipes will help you remove any impurities blocking the pipes.
step 10

After completion of work and unscrew the tap and let the water calm.

Professional Chicago Maids adn Chicago Commercial Cleaning.

How to maintain a washing machine?

August 5th, 2009 by admin

When you break the washing machine are angry, but few people remember about it by maintaining it properly. Here are some tips on how to maintain a washing machine had served us long lata.samsung_washing_machine2

Step1

Regularly clear
filter and possible settlements in the chambers of the detergent tray. After the clean laundry in the door gasket, door, enamel Wipe the outside of the cloth.
Step 2

If the washing machine has adjustable legs after each check or money still well ahead.
Step 3

When the washing machine does not work off of the contact and make sure that seeing off the pipe water is not folded or damaged.
Step 4

If a centrifuge is not working
or washing machine water not released seeing off make sure that the water pipe is not folded.
Step 5

If you need to clean the washing machine poured filter, be sure to remove the money from the earlier measure and prepare the rubber to the floor.

Professional Chicago Maids adn Chicago Commercial Cleaning.