How to replace the gasket in faucet?
August 5th, 2009 by adminReplacing seals in the battery kitchen or bathroom is very simple, but very often call for a plumber. Here you tips that will enable the exchange to you without the help of specialist seals.
Step 1
Close both the central hot water valve, and cold. Leave the tap until the with all the water pipes. On the event that the tubes sought relatively large amount of water, prepare a large bowl, cloth and old newspapers.
Step 2
construction of the battery / battery construction tap / tap
Tip of a thin screwdriver weighed the bracket, which cover the screw locking knob, use the key (put it
cloth so as not to damage the battery). The standard battery plug blue means cold water, and red – hot. The batteries of the mixers, we have only one bracket. Do not lever the fixes – if you get to them any contamination of pipes, you must replace the entire battery.
Professional Chicago Maids adn Chicago Commercial Cleaning.
Step 3
Remove the screw that you see the middle tap, turning the key in the opposite direction to traffic
clockwise. Download knob.
Step 4
You may find that you do not need to replace gaskets. Kran can run as gland may be wrong. Try to tighten it. If the water continues to drip replace gasket.
Step 5
Remove the seal at the base dławicy, the imposition of new and all down the back into place. A new gasket must be of the same size as the old. We’ll always keep two or three seals of different diameters, preferably nylon, they are more resistant, to
hot water.
Step 6
Take advantage of this opportunity is to unscrew the tap and clean the strainer, which stop at the sand and other impurities
By blocking the free flow of water. If you want to remove the stone, put it in heated vinegar and leave for ten minutes.
Step 7
After finishing work unscrew the tap water and let drain until the flow is equal to – in this way and avoid the formation of air bubbles inside of the default installation.
Professional Chicago Maids adn Chicago Commercial Cleaning.